Normally I can find what the latest firmware would be searching for the model number and it would show up, I have a second hand Arista DCS-7060CX2-32S-R here but I can't find what the latest supported firmware should be..
anyone that can tell me what it should be?
Good morning every one!
We are thinking of buying a couple of these switches for five node CEPH cluster. Since we would like to scatter nodes throughout the building we need single mode fiber transceivers with duplex LC connectors in order to use existing fiber network. Finding Arista branded...
Hello!
I am thinking of buying an Arista DCS-7050SX-72Q-R off ebay.
I know I can flash the firmware to the latest version supported (I read it's EOS-4.28.10.1M).
My main concern is around tranciever compatibility..
If I run a special command (which I think I have found), and restart the...
Hi everyone -
I've been playing around at home with an Arista 7050SX-64 and want to stack two of them together to make one logical switch that is redundant using the MLAG config.
I would also like to use 3rd party SFP+ transceivers since I'm on a tight budget.
From my research it appears...
I have a question about L2 VLANs and MLAGs on EOS hardware . (2 x Arista DCS-7060SX2-48YC6, EOS-4.20.4F)
I have the MLAG trunk setup and can ping both sides of the trunk.
I also have multiple LACP 'trunks' across both switches.
However, I can't get inter-port communication to work on any VLAN...
I have tried to start the Arista switch and MikroTik, but the same problem occurs. The nodes start and then stop after a second. The only node that works is the default Virtual PC
Hello everyone
I need to confiure mlag between 4 swithces , it will look like this
now the question is:
1. can I have the same vlan ID for mlag peer for all swithces? , for ex. vlan4094 for mlag configuration between arista1-2 , arista 1-3, arista 2-4 , will there be a problem or not , and why...
Hi All,
Been pulling my hair out (What's left anyway) for 2 days on this. Hoping to get some expert advice. This isn't my forte so bear with me. I did a quick sketch of the system.
I cannot seem to get the individual VLANS to get access to the internet through the VPN router. Intra routing...
Hi STHers,
I have an Arista DCS-7050SX-64-R:
Hardware version: 12.25
Software image version: 4.28.11M
I'm experimenting with setting up a VM on it. Following along Arista's documentation, I created a VM and copied over the qcow2 disk image onto the internal SSD (scp is crazy slow on it, for...
Has someone made the same experience to have been kicked out from the Arista forums as support contracts have expired? We are no longer able to even enter the Arista forums anymore. Support doesn't answer at all.
Greetings all,
first time posting here so please be lenient.
I recently picked up a decomissioned arista 7050SX with the intention of sticking it in front of my router or possibly replacing the switch i have running my ceph cluster.
The problem here is all of the documentation assumes you...
I'm trying to lab up a small network using Arista EOS 4.28.10.1M, Mikrotik CHR and IPv6 in EVE-NG. The aim is to actually build the same setup using an Arista 7050SX switch, Mikrotik RB5009s. However, I'm having issues with assigning IPv6 prefixes to the Mikrotiks.
Everything works just fine...
Not exactly sure if this is a super super super cheap deal, but it's still 48x 10G RJ45 ports with 4x QSFP ports. I know they are not super quiet, but turning down the fans to 40% keeps them cool and just slightly audible .... and it's ARISTA ;) All the other ARISTA switches I bought from them...
Hello. Can anyone say with certainty that the DCS-7150S models have the LIC-FIX-1-Z license by default
"Monitoring & provisioning license for Arista Fixed switches 24-36 port 10G (ZTP, LANZ, TapAgg, API, Timestamping)" ?
Will the following commands work on this switch?
(config)# tap...
Hello everyone, I am currently in the process of building a home server room, and I have the following question. Which network cards and cables will be fully compatible with the Arista DCS-7050S-R switch? I have heard that Arista switches are compatible with any SFP+ cables, is that true? Are...
Hi,
I'm trying to setup my Atista 7050s52 but failing somewhere.
I gave an ip to the managemrnt console and can ssh into it.
I'd like to connect it to say port 48 to get it reachable from other port(s).
OR
to setup vlan interface(s) with ip to make the switch reachable from those ports.
Now...
Hi all
I'm chasing some advice on how to arrange and manage some switches in the homelab.
I'm finally getting around to fixing my networking after having a my 'new' switches sitting on the shelf for a couple of years. As a background I've got:
- 2x Arista 7050T-64
- 2x Brocade ICX6450 (running...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.