bmc

Im in need of some assistance in regards to the CPU temp threshold of my supermicro motherboards. Useing the ipmitools on my linux laptop im trying to lower the CPU temp threshold. The issue is that the change is never acctually implemented. Even though ipmitools says that the temp is...

I have a S7012GM4NR with a BMC failure problem. I find that unless I cool the area around the AST2050 chip, the baseboard management controller(BMC) function stops. And by stop I mean, the flashing green LED goes out, IPMI is no longer accessible via the LAN or locally, and the VGA screen...

First off I want to say while I am just now registering I have been reading this forum for years. This community puts out a ton of quality information in the server department. I usually am able to pull what I need, but hit a problem that has me a bit stuck and this seemed like the community...

I'm new to server hardware but I've managed to get the system going by plugging in a graphics card into a PCI-e slot and then setting up IPMI, but would really like to have the VGA port working. Any display plugged into the onboard VGA port stays blank, and the screen eventually goes to sleep...

I got bored on midnights and designed a PCI bracket for the Intel AXXRMM4 remote management module. If any of you need a bracket, please try this out to see if it fits. I haven't got a chance to print it yet, but I designed it to the standard PCI bracket specs, standard ethernet cutout hole...

I have an X8DTH motherboard which I decided to upgrade the bios and BMC on. Both applied without issue according to their utils. Upon reboot the system waits for the BMC for a very long time and then eventually states that the BMC has failed. Inside of the BIOS under BMC it also shows as...

WARNING: Running the following procedure with the wrong BIOS or BMC ROM files can, and PROBABLY WILL permanently brick your node. Running the commands below can permanently brick your node ANYWAY if you look at it the wrong way. To continue, open Notepad or another text editor. Create a new...

I'm powering up the second C6100 chassis and nodes I bought back in September this year. The first went perfectly well - all 4 nodes got BMC/IPMI addresses, booted, installed OS and are now running production. The second is a ... difficult birth, shall we say. So far node 2 is fine. Node 1 I...