Quanta LB4M Management IP

Discussion in 'Networking' started by rang, Oct 19, 2018.

  1. rang

    rang New Member

    Joined:
    Oct 19, 2018
    Messages:
    2
    Likes Received:
    0
    I started configuring my LB4M this afternoon. After flashing an earlier firmware to get the Web UI, I've run into a bit of a road block.

    It appears that the management IP needs to be on the same subnet as the network IP of the router.

    My current setup is: pfSense -> LB4m -> clients on different VLANs.

    The LB4M has a static IP of 10.0.2.2 from pfSense as the network IP, but my Management VLAN (esxi, pfsense, etc) is on 192.168.4.0/24. That being said, I want to be able to access the LB4M Web UI from an address on the 192.168.4.0/24 subnet, while maintaining the static network address of 10.0.2.2 from pfSense.

    I've done a ton of reading and digging to try and find any information about doing this, but can't seem to find much. Any help would be appreciated!
     
    #1
  2. rang

    rang New Member

    Joined:
    Oct 19, 2018
    Messages:
    2
    Likes Received:
    0
    To update this:

    I have the management port plugged into a switch port (not sure if this is okay?) because I want it to pull an IP from pfSense. It did once (on the wrong VLAN), but I can't figure out how to make it pull one again.
     
    #2
Similar Threads: Quanta LB4M
Forum Title Date
Networking Quanta LB4M Web Interface Aug 21, 2018
Networking Quanta LB4M - Trunk Port Jul 21, 2018
Networking Quanta LB4M Feb 2, 2018
Networking Quanta LB4M 48-Port Sep 26, 2017
Networking Quanta LB4M - Configuration incl. VLANs Sep 26, 2017

Share This Page