Hello there
I'm trying to setup TrueNAS Core on my HP DL380p Gen8 in a ESXI 6.5 VM.
I bought a H240 HBA because I couldn't get a H220 used as some forums stated it works just fine.
I installed the card in slot 2, redone the internal wiring so I actually can use it. It shows up during the boot process with 3 Logical drives (have only one installed aswell)
In iLO4 I checked the system logs and it shows as 2 defective drives and 1 working. I believe the card is set in RAID mode instead of HBA so I want to change that. Doesn't show up in SSA so I wanted to check with SSACLI which doesn't find it either.
I'm not that experienced in Servers in general. My prior experience is with a old Workstation made into a small Bare Metal.
My P420i has 2 drives attached both seperate Raid 0
The H240 should right now have 1 drive attached, passthrough to ESXI for the TrueNAS
I attached some screenshots that maybe help?
Appreciate the help
I'm trying to setup TrueNAS Core on my HP DL380p Gen8 in a ESXI 6.5 VM.
I bought a H240 HBA because I couldn't get a H220 used as some forums stated it works just fine.
I installed the card in slot 2, redone the internal wiring so I actually can use it. It shows up during the boot process with 3 Logical drives (have only one installed aswell)
In iLO4 I checked the system logs and it shows as 2 defective drives and 1 working. I believe the card is set in RAID mode instead of HBA so I want to change that. Doesn't show up in SSA so I wanted to check with SSACLI which doesn't find it either.
I'm not that experienced in Servers in general. My prior experience is with a old Workstation made into a small Bare Metal.
My P420i has 2 drives attached both seperate Raid 0
The H240 should right now have 1 drive attached, passthrough to ESXI for the TrueNAS
I attached some screenshots that maybe help?
Appreciate the help
Attachments
-
100.7 KB Views: 2
-
86.7 KB Views: 2
-
55.9 KB Views: 2
-
136.1 KB Views: 2