I'm following this guide to reflash my IBM M1015 card to IT mode: https://www.servethehome.com/ibm-serveraid-m1015-part-4/
The motherboard is EPYC3251D4I-2T
After completing this step
I can't boot. The system hangs on
message before I can pick a boot option or enter UEFI setup.
When I remove the card the system boots normally, but without the card I can't finish loading the new flash.
How to proceed with this?
The motherboard is EPYC3251D4I-2T
After completing this step
Code:
megarec -writesbr 0 sbrempty.bin
megarec -cleanflash 0
<reboot, back to USB stick >
Code:
DXE--PCI Bus Enumeration...
When I remove the card the system boots normally, but without the card I can't finish loading the new flash.
How to proceed with this?
Attachments
-
138.3 KB Views: 10
Last edited: