i am limited in the amount of servers i can use, there isn't enough power to be bringing up storage only nodes so i can only take advantage of the N4 backplanes to use the p4610's, the p4800x goes int the chassis in a funny way.
i'm just hoping that using the ceph nodes as compute nodes as well...
here is the set up i'm thinking about building.
40G mellanox switch two switches with mclag
6 servers in total
dual 7313 epyc milan 16c/32t each
512gb ram
1 p4800x
4 p4610
40g mlx3
looking for at least two failures to tolerate, 3 would be a plus.
based off of the 6.4tb drives, 3 replicas...
i ran passmark with 768gb 4800b ram that is on the tested list:
3334.2
cpu mark 73557.7
hoping it's close to what you have @ano, it looks like it's very close to the benchmark. i guess i'll run some stresses and see where it goes.
i will check if i can manage to boot in. i had attempted to install windows 11 to an untested 0x800701B1 error. we were using a single cpu 8 pin connected 750w at my buddies and i stopped it then to bring it home.
now, i have it on a rev 1.2 pdb supermicro 2u, taped up everything needed to...
I recently purchased an Epyc 9274F below retail and was wondering, what does someone do to ensure these are legitimate and functioning processors that aren't going to burn me in the long run.
The processors look fine, they don't look modified in any way, there is a slight scratch under "MADE IN...
ouch, this hurts so much.
when they dropped to like 77 or whatever on newegg a few months ago, i called a bunch of friends and bought a ton of these for attempted vsan cache's, they're still in my drawer.
i had purchased some epycs from a seller in california, how do i know if they didn't get that from china to sell from here? i didn't know about the throttling.
would it actually have another brand on it ?
so i'm rather confused.
i have about 15 MZ-ILS3T80 (PM 1633 1632 REV 0) ish drives.
Model: P1633N38 EMC3840
Revision: EQPC
unfortunately i can't read this one in my possession but i also bought some other drives that are showing up as:
(1633a)
Product: PA33N3T8 EMC3840
Revision...
i feel like such an idiot, i had bought like 40 or 50 of these for vsan cache, then discovered i probably should be using HUSMM's in certain cases.
either way, they seem OK
while we are blaming scammers, Rand__ scammed me out of of 14.5 billion dollars, so.. please, collectively return my monies in BTC.
edit: i will take a few grand in sas ssd's or 64gb ddr4 ecc's, thanks
i bought a bunch of these
https://www.amazon.com/dp/B0B5CWK6V1?psc=1&ref=ppx_yo2ov_dt_b_product_details
and put them into H12DSI with sas 3 backplane's + N4 and nothing's being detected, on multiple servers.
i'm either not doing something right or the cables aren't the right cables.
edit, one...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.