Search results

Same problem here. If your fan curve is working, can you download the config for that only and post here, if that’s not too much.

I was able to change the threshold, so my fans idle at at 45% instead of the default 30%. Then I added 70C at 50%, that works, but whatever I put as the next level, which is 80C, it does not change anything, my RPM is stuck at 600.

I see that my 5700x is running at 74 degrees under regular load. The cpu fan and sys1 fan both stay at 450 RPM no matter what happens. I looked for fan settings in bios, but was unable to find it. Can anyone help me figure out how to change the fan curve?

Just got another email, but again there were no retailers available.

Seller listed another batch of these, I am trying to resist.

I got 4 messages like that, went to the site to see it is oos.

I also got drives from this seller from the first batch, they had very few hours. Can you please post here if this batch also has similar low hours?

These hard disks are back in stock again. Price has gone up a bit...

I want to support the seller, ordered one as well.

Thank you for testing iGPU, seems like none of us had success on that.

Thank you for this update. Does the iGPU in 5650G show up under your devices?

Thank you.

Can you let me know where you found Bios F13 please? I only see F11 as the latest.

Thank you for this, I was stuck on the bios / bmc update, finally was able to do it after this.

Has anyone tried 5800x3d on this? It is not listen on the QVL.

Codes did not work for me either:(

Sold out

I used these for SAS https://www.ebay.com/itm/284793526051?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=HWZsne0bSrq&sssrc=4429486&ssuid=p-_TxQQPRqC&var=&widget_ver=artemis&media=COPY

Are there any cheap SAS3 expanders? Or should I get two of these to run 16 drives,

Works fine with my LSI 9220.