Recent content by TheRonin

just thought id add my setup for anyone searchng for this. working fine in pfsense 2 x gbit lagg connection loadbalanced connected in modem mode to hub4 port 1+2 no issues so far.

You can pickup second hand cx mini for next to nothing. I got a cx mini in the uk for £100 + £22 van rental and £2o fuel to collect it, and looks almost brand new.

Thanks I'll look in to those rails

Got my netshelter cx mini today, there is plenty of room to fit the 846 chassis but the oem rails won't fit. So I'm either going to use universal rails or make some kind of spacer and use the oem rails.

Can anyone confirm that the supermicro sc846 fits ok in the cx mini? I'm looking to get a cx mini.

I should of checked with Supermicro first, found the answer. You don't need the DC-ATX PWR Board. The A1SAi and A1SRi Series motherboard alternatively supports a 4-pin 12V DC input power supply for embedded applications.

does the Supermicro A1SAI-275f require a power board to make use of the 4pin Dc input,or can I just plug the 4pin DC cable straight in to the board? I'm planning on useing the Supermicro sc101i itx case.

that server looks very familiar ;) small world lol

I have nut running fine on freenas setup as the master with a USB connection. My pfsense boxes run nut as slave connecting to nut on freenas. Works flawlessly.

Well I installed a Eaton 5px 3000 and one ebm in my rack, combined they use approx 25watts an hour. That's when the batteries are fully charged with a 25% load. Which I think is pretty good compared to the APC 2200 I used to have. I also have the network card which is pretty good and I'd say...

i have a couple of these in my rack, if you need any info give me a shout.

Is anyone using an eaton 5px ups? Can you tell me what the power draw is like under no load with full batteries? I currently have an apc 2200 which has broke and I'm looking to replace it with something more energy efficient. My apc draws around 120 watts under no load with full batteries, which...

Nothing is needed the backplanes fit within the same metal frame.

Yes mate its possible. Ive upgraded my 846's. Any 846 backplane will fit as far as im aware.

Im going to be useing a E3-1230 v3 ive not been able to source one yet in the uk but im hoping to order one in the next few days.