I'm trying to flash the firmware on an SAS 9200 16e from Version 5 to Version 19. I cannot get SAS2flsh to read the binary file. When trying to update the firmware I always get:
ERROR: Could not open file 9200-16e_it.bin.
It then says I have a syntax error and says I should use -f x where x is the file name.
The command I am using is:
SAS2Flsh.exe -o -f 9200-16e_it.bin
Which I am pretty sure is the correct syntax.
Any help would be appreciated. Been at this a while today.
If doing the same thing and expecting a different result is the definition of insanity, then I've definitely gone INSANE!!
ERROR: Could not open file 9200-16e_it.bin.
It then says I have a syntax error and says I should use -f x where x is the file name.
The command I am using is:
SAS2Flsh.exe -o -f 9200-16e_it.bin
Which I am pretty sure is the correct syntax.
Any help would be appreciated. Been at this a while today.
If doing the same thing and expecting a different result is the definition of insanity, then I've definitely gone INSANE!!