I am trying to flash a SAS9211-8i card and in DOS using sas2flsh and I get the following error : "ERROR: Failed to initialize PAL. Exiting program"
After reading this documentation and other forum threads, I understood that I need an older motherboard or at least one that supports BIOS32...
I'm trying to flash the firmware on an SAS 9200 16e from Version 5 to Version 19. I cannot get SAS2flsh to read the binary file. When trying to update the firmware I always get:
ERROR: Could not open file 9200-16e_it.bin.
It then says I have a syntax error and says I should use -f x where x is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.