So I bought this thing about 6 months ago, but life got in the way. Previously from a hotel, everything worked when I got it just had locked settings. Reflashed to the latest Unleashed firmware and I'm completely baffled.
eth 0 and eth1 show down in CLI. I can configure the WiFi just fine, but it never does anything with the ethernet ports (that's how I can get to the CLI; via WiFi). It will take power on the POE port, but there is no link light and the switch (ICX 7150) only sees the power draw, no logical link. The other port will show a logical link, but my UniFi control pane doesn't show ANYTHING, no matter if I tell it to request DHCP (it doesn't) or give it an IP I've set aside. Can't ping, nothing. eth0 (POE) gives me a MAC, eth1 (the one that at least shows link lights) shows all 0's.
I've reflashed twice, reset to factory, powered via POE and/or barrel jack. Is the ethernet mac done? I read some isntances of these being bricked by firmware upgrades. I hope not as I don't have a use for a mesh AP at this time...
eth 0 and eth1 show down in CLI. I can configure the WiFi just fine, but it never does anything with the ethernet ports (that's how I can get to the CLI; via WiFi). It will take power on the POE port, but there is no link light and the switch (ICX 7150) only sees the power draw, no logical link. The other port will show a logical link, but my UniFi control pane doesn't show ANYTHING, no matter if I tell it to request DHCP (it doesn't) or give it an IP I've set aside. Can't ping, nothing. eth0 (POE) gives me a MAC, eth1 (the one that at least shows link lights) shows all 0's.
I've reflashed twice, reset to factory, powered via POE and/or barrel jack. Is the ethernet mac done? I read some isntances of these being bricked by firmware upgrades. I hope not as I don't have a use for a mesh AP at this time...