I have three nodes up, that's all the cpus I have at the moment. No problems getting them to run.
Some quick notes:
iLo 4 Advanced on all three. The iLo IPs were set to static in the 172.24.0.0/24 subnet. Passwords were all default as written on the service tag of the nodes. Switching their IPs over to my subnet was pretty simple once I found their IP using nmap then just ssh in.
If you don't know iLO-speak (I didn't) then check out this quick run through of how to change the IP:
Change ILO IP address via CLI on HP C7000 Blade Chassis - Systems Administration Problem Solvers
I basically ran two commands:
set /map1/enetport1/lanendpt1/ipendpt1 IPv4Address=<your new ilo static ip> SubnetMask=<subnet mask of your network>
*iLo reboots automatically here, ssh session freezes, fans attempt to liftoff
SSH into the new iLO IP and run:
set /map1/gateway1 AccessInfo=<your gateway ip>
* another auto-reboot
Give it a minute then just browse to your new iLO web gui.
If you screw-up any of the steps and can't get to your iLO through lan like I did then you can connect to it through the serial port. After you've connected with Putty or whatever hit "Esc + Shift + 9" and you get dropped to the iLO login where you can fix the network setup.
Nodes were at:
iLO FWs are 1.22 and 1.05
System ROM at P75 04/04/2012
Ran the SPP Version 2016.04.0 on each node, with no problems. It updated iLO, System ROM, some intel thing, not sure what else. I think I'm still missing some more updates like the integrated LSI but I'm not sure. I'm firmwared out for the night though.
Be sure to thank hightail.com for dumping these so cheap =)