Hi all. I have an Cisco SFS 3001 with an OS that pre-dates the introduction of the optional Ethernet Bridging module.
I purchased the last known firmware for this switch (2.8.0) from a guy but I can't get it to copy the file.
I have it connected to my functioning SFS 3001 via CX4 cable (lights are green on both ends) and I'm hooked up to the console.
I set up an FTP server on my local network and I checked that the it's accessible from any machine on my network.
I then type the following into the console and I'm stumped:
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>HP-IB> en
en
HP-IB# copy ftp://user:password@10.10.10.110/ts280.img image:ts280.img
copy ftp://user:password@10.10.10.110/ts280.img image:ts280.img
0%
0%
0%
operation failed
Error: FTP server not reachable.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
I connected the management Ethernet cable and that didn't help.
I know almost nothing about Cisco console commands so if there's a Cisco admin out there that can help with this I'd be most appreciative.
I purchased the last known firmware for this switch (2.8.0) from a guy but I can't get it to copy the file.
I have it connected to my functioning SFS 3001 via CX4 cable (lights are green on both ends) and I'm hooked up to the console.
I set up an FTP server on my local network and I checked that the it's accessible from any machine on my network.
I then type the following into the console and I'm stumped:
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>HP-IB> en
en
HP-IB# copy ftp://user:password@10.10.10.110/ts280.img image:ts280.img
copy ftp://user:password@10.10.10.110/ts280.img image:ts280.img
0%
0%
0%
operation failed
Error: FTP server not reachable.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
I connected the management Ethernet cable and that didn't help.
I know almost nothing about Cisco console commands so if there's a Cisco admin out there that can help with this I'd be most appreciative.