Hi
Recently installed on my dell r720 H310 IT Mode which reads correctly the smart info but not the temperature. This is what im getting
not sure if its the IT card or the server itself?
Recently installed on my dell r720 H310 IT Mode which reads correctly the smart info but not the temperature. This is what im getting
not sure if its the IT card or the server itself?
Code:
root@prometheus:~# smartctl -a /dev/sda
smartctl 7.1 2019-12-30 r5022 [x86_64-linux-5.4.34-1-pve] (local build)
Copyright (C) 2002-19, Bruce Allen, Christian Franke, www.smartmontools.org
=== START OF INFORMATION SECTION ===
Vendor: SEAGATE
Product: ST32000444SS
Revision: 0008
Compliance: SPC-3
User Capacity: 2,000,398,934,016 bytes [2.00 TB]
Logical block size: 512 bytes
Rotation Rate: 7200 rpm
Form Factor: 3.5 inches
Logical Unit id: 0x5000c50040b37ef3
Serial number: 9WM7YW5G0000C2121643
Device type: disk
Transport protocol: SAS (SPL-3)
Local Time is: Fri Dec 4 21:50:05 2020 -05
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
Temperature Warning: Enabled
=== START OF READ SMART DATA SECTION ===
SMART Health Status: OK
Current Drive Temperature: 0 C
Drive Trip Temperature: 0 C
Elements in grown defect list: 0
Error Counter logging not supported
[GLTSD (Global Logging Target Save Disable) set. Enable Save with '-S on']
Device does not support Self Test logging