Recently I've had to redo my disk setup in my R410s to fit in 10G network cards. I had to remove the H200 from the PCIe x16 slot and put the 10G card in there. I noticed the server also has what dell calls a storage slot x4.
I picked up the card for this slot, which is a Dell SAS 6/IR. I wanted to just use passthrough or JBOD this time around. I believe these cards only do RAID 0 and 1.
So my question is has anybody flashed these with the LSI firmware in IT mode? And if so what firmware version and tools did you use?
I think the LSI equivalent is LSI SAS 3081E-R (IR or IT mode).
It's this type of card to avoid confusion:
http://servergoods.com/13074-home_d...for-poweredge-r410-m600-clean-tested-pull.jpg
Sent from my Nexus 5 using Tapatalk
I picked up the card for this slot, which is a Dell SAS 6/IR. I wanted to just use passthrough or JBOD this time around. I believe these cards only do RAID 0 and 1.
So my question is has anybody flashed these with the LSI firmware in IT mode? And if so what firmware version and tools did you use?
I think the LSI equivalent is LSI SAS 3081E-R (IR or IT mode).
It's this type of card to avoid confusion:
http://servergoods.com/13074-home_d...for-poweredge-r410-m600-clean-tested-pull.jpg
Sent from my Nexus 5 using Tapatalk