Has anyone else had an issue with a D-Link DGS-1510 PoE switch where the PoE stops working for no obvious reason but the switch is otherwise fine? A full factory reset doesn't cure the issue.
I have a unit that D-Link won't RMA because I have no proof of purchase, so I'm wondering if anyone else has experienced this and worked out how to fix it without RMAing, either in software/firmware or with a hardware mod?
I've got as far as opening the unit up and verifying that there seems to still be power going to both points on the board that need it - I think one is the main switch hardware (~12V) and the other is the PoE bit (~40V). I can't see anything obviously wrong with it but I'm not a hardware guy.
If no-one has any suggestions I'll just eBay it as is because I've already replaced it with a Brocade PoE switch.
Cheers.
I have a unit that D-Link won't RMA because I have no proof of purchase, so I'm wondering if anyone else has experienced this and worked out how to fix it without RMAing, either in software/firmware or with a hardware mod?
I've got as far as opening the unit up and verifying that there seems to still be power going to both points on the board that need it - I think one is the main switch hardware (~12V) and the other is the PoE bit (~40V). I can't see anything obviously wrong with it but I'm not a hardware guy.
If no-one has any suggestions I'll just eBay it as is because I've already replaced it with a Brocade PoE switch.
Cheers.