Choosing the right RJ 45 connectors for right cable?
I crimped one side of an RJ-45 on to a (soft) patch cable whose clip/ was damaged.
The whole soft cable was kind of loose under the "clamp bridge" that goes down and holds the cable (typically the solid/ strong one)
I am guessing the it was the wrong connector for such cables? I did read quite a bit about Solid vs Stranded (jacks & cables) and some RJ 45 that are dual suitable + Pins with 2 pin vs 3 pin that go down etc.
I am still unclear as there is no "clear single picture guide" that shows all varieties and their compatibles/ suitable components and leverage the same to determine and purchase the right pieces for a scenario.
One of the rare/ few listings online that points to 4 varieties but not sure it clearly outlines determining the above.
Cat6A RJ45 Shielded Load Bar x 25 50 100 lot Pack Solid Stranded Modular Plug
I crimped one side of an RJ-45 on to a (soft) patch cable whose clip/ was damaged.
The whole soft cable was kind of loose under the "clamp bridge" that goes down and holds the cable (typically the solid/ strong one)
I am guessing the it was the wrong connector for such cables? I did read quite a bit about Solid vs Stranded (jacks & cables) and some RJ 45 that are dual suitable + Pins with 2 pin vs 3 pin that go down etc.
I am still unclear as there is no "clear single picture guide" that shows all varieties and their compatibles/ suitable components and leverage the same to determine and purchase the right pieces for a scenario.
One of the rare/ few listings online that points to 4 varieties but not sure it clearly outlines determining the above.
Cat6A RJ45 Shielded Load Bar x 25 50 100 lot Pack Solid Stranded Modular Plug