Search results

Hello, We setup two servers with ConnectX4 NICs (model: MCX414A-BCAT). Servers are connected to one SX6036 switch where flow control is enabled. We want to test RoCE functions on this setup, so we use rping to test RoCE links connectivity between servers first. At initial, they can establish...

I lost the password of SX6036 switch. Trying to factory reset by pushing the reset button but no luck. The switch just rebooted without resetting password. Can it help by flashing MLNX-OS? It's ok to lost all configurations. Since it's a managed switch, I am not sure MFT can flash OS for it. Any...

Hi, We have a Mellanox SX6036 switch with ethernet support. Currently, we want to increase the receiving buffer of ports by tuning Xon/Xoff threshold. Some guides in internet metioned "ingress-buffer" and "egress-buffer" commands, but it seems that SX6036 does not have these commands. The switch...

Hello, I recently found Mellanox ConnectX-3 cards can work on both of ib and ethernet mode. I configured one port as ethernet mode and connect to an Arista 40Gb switch with QSFP cable. From the host side, a new ethernet link is detected by system and can be configured with ip address. But the...

Hello, We bought a used IS5030 switch from ebay. But only the top 18 ports can work and the rate is only 20Gb/s per port, even though we used QFP cables. It looks like a license problem. I found several numbers on the pull out tab. But it always shows Malform license key error when I tried to...