I just got my 7250-24P and I modded it with 2 times MF40201VX-1000U-G99DC. At first everything looked ok when I ran it in testing. Now I replaced my older switch with the Ruckus and sadly the fans are spinning up every x minutes.
Code:
Fan controlled temperature:
Rule 1/2 (MGMT THERMAL PLANE): 84.5 deg-C
Rule 2/2 (AIR OUTLET NEAR PSU): 39.5 deg-C
It looks like this after the fans spun up and colled it down. Then it will slowly go up to like 93 °C and then the fans go up to like 8k rpm. When they are slow they are on like 3k rpm.
I'm on
Code:
Stack unit 1:
Compressed Pri Code size = 33554432, Version:08.0.95mT213 (SPR08095m.bin)
Compressed Sec Code size = 33554432, Version:08.0.95mT213 (SPR08095m.bin)
Compressed Pri Boot Code size = 786944, Version:10.1.26T215 (spz10126)
Compressed Sec Boot Code size = 786944, Version:10.1.26T215 (spz10126)
Code Flash Free Space = 1551749120
I have connected like 6 x 1G and 4 x 10G. There is no PoE client. Apart from like 20 VLANs I've only setup one ve in VLAN 51 where I route by.
Do you have any suggestions? I'd much rather have the fans spin a bit faster in general instead of them going up every like 10 minutes.
The fans fans specs say: 18.25m3/h and 10.3 cfm.
Also the ping to the switch every x minutes goes to like 3-4 seconds latency the CLI via SSH becomes unresponsive for like a couple seconds during that time.