I am at similar state like Klee and can recommend what krista wrote.
My setup is 2x 2667 V4 and Asus Z10PE-D8 WS.
In some cases, my old 4470K is faster for games, even for normal use (and also boot speed). That is because of single core performance.
This might change with Threadripper.
I did not...
Hi again to everyone.
I was using 2x V4 QHVD in Asus Z10PE-D8 for about 8 months, where one day (well, actually deep night) the system died with CATT_ERR lit on after every boot.
I was able to isolate it to secondary CPU (the damaged one, see my old posts), because the system was working fine...
Good thing i have no plans reselling it. :)
So that is bottom right corner of the pin map posted earlier?
It seems to me more like VSS/PEG_TX-RX area, but some of the pins seems to be duplicated on the chip.
I did not know how to identify which corner is which and if the map is for socket or CPU...
About the pin damage - one of my two V4 arrived with pretty big scratch, seller HWTrade.
I used is as secondary CPU i n Z10PE-D8.
For this reason, i had to buy full load of RAM (8 sticks) and spent week with testing, to be sure.
I found nothing wrong with it, all was stable, but the seller was...
Well, i selected it mainly for the design and layout, since i have it in Thermaltake P5 wallmount case, you can see photo here:
ES Xeon Discussion
Now i have two Titan X Pascal in it in SLI (not Xp). That might be the problem.
Except for some sleep issues (it runs 24/7 anyway) and small iKVM...
Just bit offtopic note: there is new BIOS for Asus Z10PE-D8 WS, 3407, i had it available pre-release and using it few weeks, no issues noticed with V4 QHVD. Except i had to remove my graphic cards after flashing it, the board was unable to complete POST with them. Probably fixing the Intel ME...
Rock stable so far, even despite one CPU arrived with damaged pads.
See this thread:
Xeon ES/QS Turbo Bins Database
Edit: seems like i made a mistake, it is 3,2GHz. Great thing is it does not clock down much with more CPU cores load.
My general purpose Dual Xeon have 2667 V4, that is 3,1GHz max (32 threads total) and about half year ago cost 350 USD/piece, however hard to find these days.
I was not able to find faster V4 ES which would be affordable or even exist, some 2687W/269x might be bit faster, but those are not...
Yeah, now i remember.
SB-E, that is Xeon V1, right?
It seems to be hard to find details about Intel errata, so i will trust you that the V4 ES should be fine for regular use. :)
Works pretty good for me, in some ways better then previous system with retail 4770K.
I have V4 ES2 and it is rock stable, so do not know how that can be better.
I was thinking differently - o went for V4, because there is probably no major changes over V3, it is just a next iteration.
So i was thinking, even if for example V3 ES2 had some issue, it will be already fixed in V4...
Well, i would not expect that to work.
Of course you can try it, if you will have the option to return the RAM if needed, but to me it seems like a wrong thing to do, it is just not meant to work. Just expect there might be a problem.
For me, i went the safe way, because i think 64GB (in my...
I think it might work only if the chipset is not C610 (like X99).
The only memory which worked with even single CPU on Z10PE-D8 WS was Registered ECC.
Unregistered ECC does not work too (that was mistake i done).
One problem i have however. I just found it now.
When i try to do S3 sleep, the system does not boot on wake up, ending with error E1 (S3 boot script execution) and red CATTERR light.
Hibernation work correctly. Both sleep modes fully power off the system, so it takes around 30 seconds to wake...