Confirming what Rollo said- spoke (Via email) to the Infineon helpdesk folks today. DON’T buy the USB005 (like I did).
quoting:
USB005 works with all GUIs except PowerCode. PowerCode is the only software you can use to communicate with PXE1610C.
I asked them where I could get the part @RolloZ170 noted above, since all the retailers are out of stock… they told me that if I had an FAE (Field Application Enfineer), I could have them order me one… the image they shared with me showed the low, low price of only 4,347 Euros, $4871.70, or 521640 Japanese Yen….(And unless I misread, you have to order 5 at that price… such a deal!) I replied with a screenshot of the Digikey price and told him that While I appreciated that they were available (at 70x the retail price), I was going to put my project on hold.
Honestly? They were super helpful and confirmed what I needed confirmed (Since I had not seen @RolloZ170 ’s post at that point.
SO… anyone near Houston have one they can loan me, or willing to let me leave a “deposit” with them for?
*Or* are there any other solutions out there to edit the controler values?
I appreciate all the knowledge shared in the posts above- it’s opened my eyes to i2c, and a whole host of system management things I had never even considered!!!
quoting:
USB005 works with all GUIs except PowerCode. PowerCode is the only software you can use to communicate with PXE1610C.
I asked them where I could get the part @RolloZ170 noted above, since all the retailers are out of stock… they told me that if I had an FAE (Field Application Enfineer), I could have them order me one… the image they shared with me showed the low, low price of only 4,347 Euros, $4871.70, or 521640 Japanese Yen….(And unless I misread, you have to order 5 at that price… such a deal!) I replied with a screenshot of the Digikey price and told him that While I appreciated that they were available (at 70x the retail price), I was going to put my project on hold.
Honestly? They were super helpful and confirmed what I needed confirmed (Since I had not seen @RolloZ170 ’s post at that point.
SO… anyone near Houston have one they can loan me, or willing to let me leave a “deposit” with them for?
*Or* are there any other solutions out there to edit the controler values?
I appreciate all the knowledge shared in the posts above- it’s opened my eyes to i2c, and a whole host of system management things I had never even considered!!!