Ubiquiti EdgeRouterX SFP

[ELit3]

Im trying to setup my ubiquiti router but the configs don't seem to be working out for me.

There are a few setting that I'm not familiar with in the GUI such as WAN+2LAN and WAN+2LAN2. The way I am trying to configure the router is eth0 static IP for management and then eth1, eth2, eth3 and eth4 to be configured on their own subnet such as 4 /28 subnets so that my access points can pull DHCP from them. What setting would this be? Right now I have the GUI up and running off the switch settings but none of the ports will pull DHCP.

 

[K D]

I seem to remember the ER-X (non sfp) had a wizard that set each port jn it's own subnet. However the management ip could be reached from all subnets. You would have to set up firewall rules if you want to block access from all but one.