I have a switch that has had the firmware erased. Upon booting, it gets tons of image failures and I have, so far, been unable to remedy the issue. I have attached a screenshot of the errors in PuTTY. I have a config file stored on a USB, however, thus far I am unable to run the file from the USB.
As you can see, after the initial check of hardware, it doesn't go any further. Can anyone give me some direction on this; on how to get this fixed?
As you can see, after the initial check of hardware, it doesn't go any further. Can anyone give me some direction on this; on how to get this fixed?
Attachments
-
237.6 KB Views: 28