Hi folks.
Me again with a question regarding Supermicro X9DRL-3F. I just bought a 2nd processor to install on my MB, but when are both installed the motherboard doesn't turn on, I see the leds on it, but nothing else. When testing each processor individually it works as a charm, doesn't matter if I use CPU1 or CPU1 on the motherboard.
The processors in question is an Intel Xeon E5-2603V2. Is there any jumper to change or any firmware update I should do before installing a 2nd processor? I thought could be my PSU, but I have one Corsair CP-9020091-UK RM650X 650 that is suppose to support this configuration.
Any advise?
Thank you in advance.
Me again with a question regarding Supermicro X9DRL-3F. I just bought a 2nd processor to install on my MB, but when are both installed the motherboard doesn't turn on, I see the leds on it, but nothing else. When testing each processor individually it works as a charm, doesn't matter if I use CPU1 or CPU1 on the motherboard.
The processors in question is an Intel Xeon E5-2603V2. Is there any jumper to change or any firmware update I should do before installing a 2nd processor? I thought could be my PSU, but I have one Corsair CP-9020091-UK RM650X 650 that is suppose to support this configuration.
Any advise?
Thank you in advance.