Hey all. I'm trying to fill my MD1220 but it will only recognize at most 5 drives.
I have done the following:
Confirm all drives function individually
Confirm all 24 bays recognize a drive when used individually
Confirm that the enclosure is not the issue (I have 25x MD1220s and have tested 3 different enclosures)
Confirm that the controllers are not the issue (See above)
Confirm that the PSUs are not the issue (See above)
Confirm that my 8088 cables are functioning (Tried 10 different cables)
Confirm that my 9207-8e HBA card is functioning (Tried both ports)
Confirm 9207-8e is in IT mode on newest firmware (20.0...)
Confirm drivers are installed on Linux (ubuntu) host (20.0...)
The drives used are Seagate Barracuda Compute 5tb (ST5000LM000)
My host computer is a X299 platform, 10980xe. Using a LSI 9207-8e HBA card.
I do not plan to put my drives in a RAID array.
I'm at my wits end and appreciate any and all assistance.
I have done the following:
Confirm all drives function individually
Confirm all 24 bays recognize a drive when used individually
Confirm that the enclosure is not the issue (I have 25x MD1220s and have tested 3 different enclosures)
Confirm that the controllers are not the issue (See above)
Confirm that the PSUs are not the issue (See above)
Confirm that my 8088 cables are functioning (Tried 10 different cables)
Confirm that my 9207-8e HBA card is functioning (Tried both ports)
Confirm 9207-8e is in IT mode on newest firmware (20.0...)
Confirm drivers are installed on Linux (ubuntu) host (20.0...)
The drives used are Seagate Barracuda Compute 5tb (ST5000LM000)
My host computer is a X299 platform, 10980xe. Using a LSI 9207-8e HBA card.
I do not plan to put my drives in a RAID array.
I'm at my wits end and appreciate any and all assistance.