Hi!
I try to use led pins to see conditional status from hdd.
I'm manualy setting controller to faulty status, but led is not blinking. Only beeping.
But I can start to blink led with direct command - "locate drive"
firmware 12.15.0-0239
Who uses this LEDS?
I try to use led pins to see conditional status from hdd.
I'm manualy setting controller to faulty status, but led is not blinking. Only beeping.
But I can start to blink led with direct command - "locate drive"
firmware 12.15.0-0239
Who uses this LEDS?