Intel S2600CP LAN adaptor not appearing in Win2012R2

[Acesi7]

Hey Guys,

Hoping you can help out, just finished a E5-2670 build, and fired everything up into Windows Server 2012r2.

Everything is looking good except it's missing the 2 onboard LAN adaptors in Devices.

Any ideas? When I run the Intel driver install it says no devices found...?

I've been using a Intel 4-port PCI-E NIC so it's not a huge problem, however I would like to use these onboard LAN ports for management.

If anyone can shed any light it would be greatly appreciated.

Cheers guys.

 

[rubylaser]

Did you check to make sure that they aren't disabled in the BIOS or any motherboard jumpers aren't set to disable the NICs on the board (I'll have to check the manual and see if this board has jumpers to disable the NICs)?

Intel S2600CP Service Manual (Page 129 of 187)

 

[Stereodude]

Mine were disabled in the BIOS on the board I received from Natex. I had to enable them.

 

[Acesi7]

Did you check to make sure that they aren't disabled in the BIOS or any motherboard jumpers aren't set to disable the NICs on the board (I'll have to check the manual and see if this board has jumpers to disable the NICs)?

Intel S2600CP Service Manual (Page 129 of 187)

Mine were disabled in the BIOS on the board I received from Natex. I had to enable them.

Thanks for the info guys.

Mine also had them disabled in BIOS. Appreciated the advice all working now.

Cheers.