You can use the 2 OPT_12V close by the PCIE_RISER, you just need a 4 Pin Molex To P4/64 Bit ATX 12vGreat it works .
Any idea where i can get sata power connection for the internal SATA connectors ? there ist no molex or similar connector
I thought 2.5 drives needed 5v but the connector is only 12v only.You can use the 2 OPT_12V close by the PCIE_RISER, you just need a 4 Pin Molex To P4/64 Bit ATX 12v
Anything like this will get you a molex, and then you can use a splitter form molex to SATA.
If you check properly it gets the power from the 12V, however, on the molex side its only 5v. As is it is connected and with the ground cables.I thought 2.5 drives needed 5v but the connector is only 12v only.
There is a proper connector on the board that's used to supply a optical drive. It's a bit of a odd connector. I have the links to the details I will post later. Think I'm going to make my own connector up.
The connector is up front in the middle, it's fairly small.
Sent from my MI 5 using Tapatalk