Megarec doesn't see the SAS2208 controllers, so you can't get or flash the SBR's to cross flash.Is there anyway to flash Intel RS25DB080 to 9270-8i? I've got an Intel RS25DB080 which I'm pretty sure is LSI 9270-8i rebranded. As Mobilenvidia pointed out Megarec doesn't seem to recognize SAS2208 chips.
ServeRAID m5016 SAS/SATA Controller Firmware Update for Windows
Adapters Supported: ServeRAID M5016 SAS/SATA Controller for IBM System x (90Y4304)
NOTE TO SERVICE - Reference RETAIN #N/A
Version 23.12.0-0011 - Suggested
-------------------
Enhancement(s):
- Changed BIOS check to determine if running in HAMR, in order to ensure nothing
gets broken when user has an iButton which is not programmed.
- Changed controller status for safe mode to show controller status as safe mode
and disable debug message logging in serial port.
Fix(es):
- Fixed an issue where HII hangs when trying to enter configuration
management while in safe mode. Changed the safe mode warning message as below:
"Controller is running in safe mode. Safe mode is used for diagnostic purposes
only. Limited operations such as Configuration Preview, Clear Configuration
and View/Change Controller Properties are allowed in this mode. Other
operations such as Create Configuration, Import and Clear Foreign
Configurations are not allowed. To exit safe mode, correct the fault, and
reboot your computer."
- Fixed an issue where having more than three adapters results in a
calculation error for the offset to store physical disk info for fourth adapter,
due to BIOS not clearing upper byte of AX (that is AH which is containing
some non zero value).
- Fixed an issue where the Wrong spanned drive group size is displayed
by WebBIOS (Ctrl-H).
Version 23.16.0-0027 - Critical
-------------------
Fix(es):
- Addressed data exposure issue when using CacheCade
- Fixed issue where Supercap shows 0 Capacitance
- Fixed iBBU08 and iBBU09 battery issue that caused a VD cache policy to
remain in write-through mode after a manual relearn
- Fixed iBBU08 and iBBU09 battery issue that caused a VD cache policy to
periodically toggle between write-back/write-through mode
- The limits for iBBU08 and iBBU09 battery charging were not updating properly
in a learn cycle
- Ensures a single supercap pack is not supported on 2GB memory module.
- Resolves a firmware crash seen while doing continuous sas cable pulls.
- Ensures OpROM loads even if segment address is 0xC0000.
- Fixed an issue where the adapter is running iMR machine checking after
requesting host memory.
- Fixed an issue where HII does not allow the user to make use of the remaining
free capacity to configure additional VD for R50/R10.
- Fixed an issue where an HII: empty warning prompt is given when creating a
CacheCade VD with forced writeback option.
- Fixed and issue where Windows cannot install without a VGA device on board.
- Fixed and issue in EFI WebBIOS were consistency check is still shown in
progress after 1 PD is removed from a R1 array.