HPE FlexFabric 20/40 F8 Module. 40G ports doesn't work

[dimka890]

Hi all. I need help.
FlexFabric 20/40 F8 module is connected to Cisco 9396PX with 40GbE QSFP-CR4 DAC cabels
VC Q1.1 port status is "Not Linked". From Cisco side also No Link
I have two such modules, two cables, both are connected to Cisco and both have this status. I don't know what to do with me
VC Side:

->show uplinkport enc0:1:Q1.1
ID : enc0:1:Q1.1
Enclosure : CZ3327J632
Status : Not Linked
Type : QSFP+CR4 (external)
Speed : Auto/Auto
Used By : -- --
Label : Q1.1
PID LED State : off
LAG ID : -- --
Connected From : -- --
Connected To : -- --
Paired With : -- --
Autonegotiate : Default

Cisco side:

Cisco40G# show int Eth2/2
Ethernet2/2 is down (Link not connected)
admin state is up, Dedicated Interface
Hardware: 10000/40000 Ethernet, address: 881d.fc5b.14d9 (bia 881d.fc5b.14d9)
MTU 1500 bytes, BW 10000000 Kbit, DLY 10 usec
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, medium is broadcast
Port mode is access
auto-duplex, auto-speed, media type is 40G
Beacon is turned off
Auto-Negotiation is turned off
Input flow-control is off, output flow-control is off
Auto-mdix is turned off
Rate mode is dedicated
Switchport monitor is off
EtherType is 0x8100
EEE (efficient-ethernet) : n/a
Last link flapped never
Last clearing of "show interface" counters never
0 interface resets