timestamps
For sale:
#1 SuperMicro 216, 24-bay, 2U SFF Chassis
#2 SuperMicro 216, 24-bay, 2U SFF Chassis
No rails included because I don't have them.
Please keep in mind the Adaptec 71605 controller is a SATA/SAS 6 Gbps controller, so you won't see full lane saturation on any one single device with the 12 Gbps SSDs but maybe you could theoretically with 16 devices? These controllers were just cheap and highly available alternatives to more fussier HBAs that usually required some degree of cross-flashing. I would highly recommend strapping a 40mm fan to the heatsink. It doesn't even have to be an exceptionally sturdy one, just get some airflow over it.
Local pickup only in SE Houston / Clear Lake area. Any questions, send me a PM. Cash or Zelle only.
cross posted on /r/homelabsales
For sale:
#1 SuperMicro 216, 24-bay, 2U SFF Chassis
- SuperMicro X10DRH-iT Motherboard (Onboard 10GbE Copper)
- Dual E5-2680 v4 CPUs
- 256GB RAM DDR4 2400 ECC, 8x32GB DIMMS
- Rear 2x2.5" SATA/SAS Drive-cage (currently wired for SATA only)
- Dual PWS-920P-SQ Power Supplies
- SAS3 Backplane /w Expander BPN-SAS3-216EL1
- Adaptec 71605 Dual-mode Controller (Does RAID or HBA Modes)
- 24x Intel S3700 800GB SSDs, all tested and working showing 100% life remaining in Intel SSD Toolbox
- 24x Trays NOT SHOWN BUT INCLUDED! The drives will be installed into trays prior to pickup
- asking $1350
#2 SuperMicro 216, 24-bay, 2U SFF Chassis
- SuperMicro X10DRH-iT Motherboard (Onboard 10GbE Copper)
- Dual E5-2680 v4 CPUs
- 256GB RAM DDR4 2400 ECC, 8x32GB DIMMS
- Rear 2x2.5" SATA/SAS Drive-cage (currently wired for SATA only)
- Dual PWS-920P-SQ Power Supplies
- SAS3 Backplane /w Expander BPN-SAS3-216EL1
- Adaptec 71605 Dual-mode Controller (Does RAID or HBA Modes)
- 24x HGST HUSMM8040ASS200 400GB SAS3 12 Gbps SSDs, all tested and working with 0% wear indicated using smartctl -a /dev/sdx --device=scsi
- 24x Trays NOT SHOWN BUT INCLUDED! The drives will be installed into trays prior to pickup
- asking $1200
No rails included because I don't have them.
Please keep in mind the Adaptec 71605 controller is a SATA/SAS 6 Gbps controller, so you won't see full lane saturation on any one single device with the 12 Gbps SSDs but maybe you could theoretically with 16 devices? These controllers were just cheap and highly available alternatives to more fussier HBAs that usually required some degree of cross-flashing. I would highly recommend strapping a 40mm fan to the heatsink. It doesn't even have to be an exceptionally sturdy one, just get some airflow over it.
Local pickup only in SE Houston / Clear Lake area. Any questions, send me a PM. Cash or Zelle only.
cross posted on /r/homelabsales
