Cisco WLC 2504 rackmount ears.. 3D printed?

Discussion in 'DIY and Makers Spot' started by maze, May 16, 2019.

  1. maze

    maze Active Member

    Joined:
    Apr 27, 2013
    Messages:
    547
    Likes Received:
    79
    been looking at buying a pair but the Price gets on my nerves..

    Anyone happen to have printed a set of these?

    Og not, to the drawingboard! :)
     
    #1
  2. Derwood

    Derwood New Member

    Joined:
    May 22, 2019
    Messages:
    24
    Likes Received:
    0
    I've a Fused Filament Layer 3D printer and have used both PLA, ABS but I'd wonder about the weight handling of the item first, however have a number of ears left over from some DELL nodes and I wonder if you could repurpose them too.

    Definitely give FFL or SLA a go first though because it's such a simple shape and it would not take to long to rapid develop or print out.

    Nice idea!
     
    #2

Share This Page