Well I have this two chembro's cases and wanted to replace the motherboards that came with them so I needed to modify the pin headers to match the new boards connectors. I think I did it well, but since my head ins't as bright as it should be (no much difference than normal working condition but a fisure on my foot is killing me) I would like to be sure that I did it right.
The important one is the RM238, there is where I want to install the board that come with the RM14604, but there are cable to the front panel is soldered to it and it is just a flat ribbon cable with no identification colors (here is where I could have made a mistake)
If some one with chembro account could get info about their pinout (there is not info on the manuals etc downloable at their site), I will be thankful.
The important one is the RM238, there is where I want to install the board that come with the RM14604, but there are cable to the front panel is soldered to it and it is just a flat ribbon cable with no identification colors (here is where I could have made a mistake)
If some one with chembro account could get info about their pinout (there is not info on the manuals etc downloable at their site), I will be thankful.
Last edited: