Building my own HP DL585 G7

[nusi]

Hi, guys have those components:

1) AMD Opteron 0S6238WKTCGGU 6238 FA 2011 2.6GHz 12-Core Processor"
2) HP 460W Common Slot Gold Hot Plug Power Supply (HSTNS-PL14) ProLiant G6/G7/G8"
3) AMD Opteron 6220 3.0GHz 8-Core 16M Socket G34 CPU Processor OS6220WKT8GGU
4) Genuine HP DL585 G7 Server Board 5x PCI-e Expansion Slots 604046-001 w/ Warranty
5) Micron 16GB HP Server Memory RAM 4x 4GB PC3-10600R ECC REG DDR3 1333 RDIMM LOT
6) Lot of 2 Genuine HP 604054-001 ProLiant DL585 G7 Processor Heatsink 596135-001
7) 591202-001 HP Proliant DL580 G7 DL585 G7 Power Supply Backplane Unit 590515-001
8) 604047-001 - HP Proliant DL585 G7 Primary System Processor & Memory Motherboard
9) HP ProLiant 512844-001 DL580/DL585 G7 SPI Riser Board 591199-001 617527-001
10) 570451-101 579229-001 HP 1200W High Efficiency Power Supply G6 G7 Quantity Avail

But cannot boot up, because have no power button, that may sound ironic.
I do not know which pins to connect to boot up. I even have no any clue which board have those pins on the SPI board, Expansion Slots, Primary Board or Backplane unit.

Thanks in advance!

 

[Marsh]

Could you connect to "HPE Integrated Lights Out (iLO) Remote Server Management" via network?

Then power up the server using the iLO web interface

 

[nusi]

I have just obtained license key for 60-days trial.
Also downloaded HPE iLO for android, it requires
"iLO network address", "login" name and "password", just to be clear, I have no connected HDD/SSD and no Video Card with no OS there. I just want to be sure that I can run it? Or having SSD is crucial to make sanity check?


As I understand i need to connect ethernet cable on SPI board to my router to connect to the internet.
According to the documentation I have connected to "iLO 3 connector" the ethernet port which prior to USB ports. (see attachment)

After connection neither of indicators on iLO ethernet port do not blink (on PC they are usually blinks even if OS is not running)
During plugging both power supplies (1200 W) they are making a very little noise at start for few seconds(probably that they are connected) and also there is no green light on both of power supply unit(see attachment). Is it normal at this point?

 

[Marsh]

You do not need OS , disk to use iLO.

If you are lucky, check your DHCP server to see if your frankenstein HP acquired a IP address.

 

[Marsh]

In case your frankenstein HP did not acquired a IP address.

Try google "wireshark determine ip address"
Here is a youtube video on how to use wireshark to determine unknown ip address.

If you don't see any sign of network activity , troubleshoot your iLO/IPMI board.

 

[nusi]

Ok, so far, I do not see any sign.
how troubleshoot my iLO/IPMI board?
Could I use multimeter?

 

[nusi]

I have to freeze this project because , there is no sign of life there, going to buy one complete 585 g7 drawer to understand its guts.