Hi everyone,
working on a small project where I need to create a drawing using assembly.
My question is is there anyone on the forum sam has experience with assembly? So that he/she can guide me a little bit.
I would be very grateful if I could get some help. It does not need to be advanced. Is enough with a short video with steps or a small guide.
With kind regards Sejtan
working on a small project where I need to create a drawing using assembly.
My question is is there anyone on the forum sam has experience with assembly? So that he/she can guide me a little bit.
I would be very grateful if I could get some help. It does not need to be advanced. Is enough with a short video with steps or a small guide.
With kind regards Sejtan