I want to directly connect two computers using two Intel XL710-QDA2 40Gbps PCIe 3.0 x8 cards. However, the only slot I have available on my MSI x670-P Wi-Fi motherboard is a PCIe 4.0 x 2 slot (the physical slot size is x16). See "PCI_E4" in the diagram below:
If the card I would put in the...
[EDIT] After 2+ more hours I think I have found an answer. Nope.
Every article I see talks about compatibility of using older 40Gbit QSFP+ optics in 100Gbit QSFP28 switches.
Does the opposite work?
I doubt it, but it would be good to know.
I'm on a shoestring budget and I'm encountering...
I just recently purchased the MikroTik CRS354-48G-4S+2Q+RM switch to expand my server's networking capabilities. However I have seem to run into compatibility issues. The switch wiki says it only supports transceivers/cables made by MikroTik, I already bought cables from FS.com and I can't find...
Hi all! I'm attempting to use these apparently coveted (and cheap) HP/Mellanox cards for a switchless, high-speed homelab configuration. I thought I knew what I was getting myself into when I ordered everything... however, I'm just now realizing after purchasing the equipment that it may not...
Hi,
I am wondering if I buy a QSFP+ to SFP+ Breakout cable, like one of these:
40G QSFP+ Cables, QSFP+ to 4 SFP+ Breakout Copper Cables
Do I need to plug in all 4 SFP+ cables or can I just use one or as many as I like?
I am asking since I have a QSFP+ switch (Mellanox) - and a Netgear switch...
I have a few ConnectX-3 cards with dual QSFP+ ports on each and I'd like to have their capacity available for a local LAN party (36 total 1G ports required) without breaking the bank. The problem is the QSFP+ enabled switches common in the US are either much more expensive in the EU or just...
Hello all,
I was thinking, for my living room where I have quite a few servers running (silent !), to do a custom 10gbe IPoIB setup. In my lab room I could use the Voltaire 4036 (non-E version unfortunately) which I still need to find a way to silence. It's way too noisy even for the server...
What's the functional difference?
The reason I ask is because I have an Arista 7050QX-32-S (24x QSFP+ 4x10G-capable-ports and 8 QSFP+ 40G-only-ports) and recently I picked up some Arista 40G-UNIV transceivers expecting, perhaps niavely, for them to functionally be an SMF/MMF compatable version...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.