lb6m

  1. T

    LACP configuration

    Hello friends! I am trying to configure LACP between my Juniper SRX240 (JunOS 12.3) and Quanta LB6M. So far, I'm stuck. Let me show you my current configuration on both devices. Quanta LB6M configuration interface 0/25 addport 1/1 exit interface 0/26 addport 1/1 exit interface 0/27 addport...
  2. D

    Quanta LB6M Stacking question

    Hi, I have 3 Quanta LB6M with 1.2.0.14 firmware (FastPath). Right now they are daisy-chained with LACP on ports on the same switch. Has anyone been able to stack these servers to achieve redundant LACP? I'm thinking of updating the firmware, but cant afford bricking it. Any help would be...
  3. M

    LB6M Bricked Need Help

    I think i bricked my LB6M. Something went wrong during flashing to brocade and I no longer can access it using the console. As soon as the switch is powered on the MGMT 1 and 2 port lights are on. The fans stay at full speed and never reduce speed. If anyone can help with this issue would really...
  4. A

    Quanta LB6M dead console until reboot

    So I've been running this Quanta LB6M I got on eBay for the last 2 years with no problems except when I want to plug another device into the switch. Unless the ports are in use they won't work until I reboot the switch. It has zero configurations. I literally turned it on to make sure it was...
  5. fohdeesha

    Turbocharge your Quanta LB6M - Flash To Brocade TurboIron - Big Update!

    UPDATE 7/11/2018 - It's been discovered that the version 8 Brocade firmware originally on the site was an internal-use only, untested beta version. It has been removed from the guide and replaced with the latest v7 mainstream release which is rock stable, well tested and has had a few more...
  6. V

    LB6M and PfSense vlan routing issue

    I have read a ton of posts on here and tried just about everything I could to try and get my LB6M to "trunk" data to my firewall. I am trying to build a router on a stick configuration. FW Config <?xml version="1.0"?> -<pfsense> <version>15.5</version> <lastchange/> -<system>...
  7. X

    Network design help.

    Hi all, I have been browsing for a while and posting an answer here and there, but I am to the point in my new lab/network build out that I need a bit of help. I have a 2gbps fiber loop being installed at the end of January and I decided to start getting everything ready for it. Until this...
Top Bottom