Search results

I would try disabling any "on-motherboard" drive controllers and make sure raid (if available) is also disable for the chipset drive controller also disconnect any drives attached to the motherboard! If it still won't boot then i would suspect compatibility with your motherboard. On my x58...

Yeah it actually turned up fitted together, battery cable connected but also a spare "battery to IP board" cable, It cost me $60 so i don't think it's too bad overall, i may ask to keep this if the replacement is the same then i will have just over the lifespan of a new one, just swap them...

Does anyone know if just the battery is obtainable on its own without the interposerboard? Or are these tied together and have to be bought together?

Thanks for the confirmation, i have contacted the seller with my findings and he has offered to replace it, so i'll wait and see what the replacement is like, hopefully new as he stated. I have a feeling though that he has bought a cheap batch of batteries that have been removed/swapped out...

So it look like it's lost around 420mah/3rd of the capacity.

Hmm thats what i thought, thank's guys! This is what i get now it's charged..... MegaCli has this report on the BBU

Anyone? I think this is SH because of the "complete discharge cycles" are at 39 times, this should be near 0 if new?

Ok, battery turned up today and it is a bbu07 type and had a spare battery cable and 3 screws. I have installed it and it's currently charging up, however this is suppose to be new but looks like it's had use as per below... Has this been heavily used and is second hand?

Hi, I have a good deal to get this battery really cheap and ask if it will work fine on a standard 9260-8i, This a dell supplied battery, Dell Part number # 0H21G I can't find much info on this but looks like a LSIiBBU07 type. I contacted the supplier for exact parts list included and this...

Ah great, thanks again!

Whats the actual file name for this part firmware with bios v3.25, please?

Problem is now solved, thanks mobilenvidia! First tried setting drive spinup (was set to 4, now set to 2) - didn't work. Swapped over 8087 connectors, 4 x 1tb now on ports 0-3 and 2 ssd's on 4 and 5, - result, ssd no longer disappears. Thanks!

Look forward to your tests:)

Thanks a lot mobilenvidia, i'll try your suggestions and report back.

Hi, I have a strange problem that i have been able to replicate across an IBM 5014 (Lsi sbr + 9260-8i firmware and default IBM sbr + IBM firmware) and an original Lsi 9260-8i card. I have 4 x 1TB raid 0 on ports 4-7 and added 2 x samsung 830 128gb SSD drives to ports 0, 1 @ raid 0! When...

Hi, Its a standard PCI-e x8 Controller card not a module, same as this one.... http://www.shopping.com/dell-dell-r374m-perc-h700-sas-sata-controllers/info I think the modular card is a 512mb cache add-on card for the lower Perc H700 512mb to make it 1gb total. The one i found is single...

Hi, i've come across a good deal for a Dell Perc H700 1gb Cache + BBU @ $280, which i believe is SAS2108 based 5014/5 equivilent with all the features like cachecade, raid6 etc.. naturally available without the need for a soft/hard key (1gb Cards only), so currently re-searching this card and...

Thanks for the tip Rimblock! I suppose it going to be a case of suck it and see, if i do run into trouble i'm sure i could source a loan PC from work! Thanks.

Ok thanks for all the help!

Ah ok, i do have an intel branded motherboard PC - based on SKT 775, would this be ok for flashing?