It was Victoria 5.36, it has hitachi commands support. It did not allow me to do low level format in SATA mode, so I connected the drive by USB and after that I "succeded". (yes, I know it was silly) :(
It persists. And diskpart does not help:
DISKPART> create partition primary
Disk is uninitialized, initializing it to GPT.
DiskPart has encountered an error: Data error (cyclic redundancy check).
See the System Event Log for more information.
Hi,
I have a problem: SMART status of my drive is "unknown". It is also not possible to write or read the drive, it cannot be initialized, too. Though, I can see the right size of the drive and all SMART parameters except Threshold. As far as I know, it happened after unsuccessful low level...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.