Recent content by m0t0rh3ad

  1. M

    Supermicro M11SDV-8C-LN4F memory population issue

    I think I've found solution - set Memory Freq Manually.. testing right now... In MB manual I found next - if 4 Slots populated - Memore Freq - 1866Mhz, but I can see - 2133MHz during performing Tests, I set manually - 1866MHz, and I can install ESXi and run Hypervisor, now checking everything PS...
  2. M

    Supermicro M11SDV-8C-LN4F memory population issue

    Memory test ok, support recommended downgrade BIOS to 1.0b, done, but no result...
  3. M

    Supermicro M11SDV-8C-LN4F memory population issue

    ok, will try with memtest. Right now I'm testing every module in single mode (one by one) with superdiag because support requested this.
  4. M

    Supermicro M11SDV-8C-LN4F memory population issue

    Hynix RDIMM (photo). I've tried 1 module (A2,B2), 2 A2+B2, 3 A1+A2+B2 (manual recommends such config for balanced population https://www.supermicro.com/manuals/motherboard/EPYC3000/MNL-2172.pdf). MB runs good with 3 modules with OS, with 4 Tests ok, OSes not booting... Also I've tried to...
  5. M

    Supermicro M11SDV-8C-LN4F memory population issue

    Hello, I've got MB Supermicro M11SDV-8C-LN4F and have such problem. when all DIMMs (4 slots) populated MB can pass Memtest and SuperDiag Tests (Supermicro tool), but I can't install OS, I've tried ESXi and Linux - boot loop - installer starts and then reboot... When Im using 1-2-3 slots...
  6. M

    Upgrade LSI 2116IT in X10SDV-4C-7TP4F to P20

    Does anyone have a successful firmware upgrade on Supermicro X10SDV-4C-7TP4F or another Supermicro MB and Broadcom 2116 in IT Mode?