Similarly.. I'd guess this stacking isn't far off
Switch A Configuration
enable
config
stack
stack-port 1/1/1 stack ! configures interface 1/1/1 as a stacking port
stack-port 1/1/2 stack ! configures interface 1/1/2 as a stacking port
exit
exit
reload
Switch B...
fyi.. on the LACP issue. The OS is broadcom's fastpath, which is the same as HP moonshot uplink modules. I pulled a bit from some manuals I had . This shows a static LAG. dynamic is similar except .. port lacpmode instead of no port lacpmode
enable
config
interface 1/1/1,1/1/2
addport 0/3/1...
Has anyone been able to replace vxWorks with U-boot? I noticed in the pica8 documentation it mentioned loading the diagnostic image and under the vibration test
Enter your choice: <=====Ctrl+D twice
This takes you to a place you can launch a shell, etc. I looked around without success
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.