Recent content by Emek

  1. E

    EU SOLD FS: 16x 16GB DDR4 ECC 2Rx4 2133 HPE 726719-B21 752369-081

    16x 16GB DDR4 ECC 2Rx4 2133 HPE 726719-B21 752369-081 Samsung modules. Taken from a new server. 0 hours. Shipping from Denmark. 45 40 35 EUR each or 600 550 500 EUR for the lot. Payment by PayPal. SOLD Also om eBay: 16GB DDR4 ECC 2Rx4 2133 HPE 726719-B21 752369-081 | eBay
  2. E

    EU 35 x Samsung / Cisco 32GB DDR4 = 84 euro

    Is the DL380 gen9 LFF or SFF and how many slots?
  3. E

    Beware of EMC switches sold as Mellanox SX6XXX on eBay

    Try and switch cable with a known good one. If that doesn't work, move over the cable to another port on the switch first and client second. If that doesn't work it seems you have a bad card in the client.
  4. E

    Beware of EMC switches sold as Mellanox SX6XXX on eBay

    Do you have a DHCP server or configured static IP's. If so can you ping the server?
  5. E

    40GbE - will that hardware combination work?

    Infiniband only.
  6. E

    40GbE - will that hardware combination work?

    MSX6025T-1SFS is unmanaged Infiniband only. You need 6012, 6018 or 6036 + gateway license if you want ethernet. The cards are connectx-2. 3 is Better and not that expensive. The cables should be ok, but DAC would be cheaper. I have some switches and cards if you're interested.
  7. E

    Mellanox SX6018F Connection Issue

    Ah, your'e right. Maybe someone flashed the wrong firmware...
  8. E

    Mellanox SX6018F Connection Issue

    The cables are not detected. When a transceiver or a cable is attached the port should light up in the image above. Try and click on the port where the transceiver is attached, and see og there's any info. Did you change settings without clicking save?
  9. E

    Mellanox SX6018F Connection Issue

    If the subnet manager is running then it should be working. Can you see the cables under "ports"?
  10. E

    Mellanox SX6018F Connection Issue

    If ethernet: You need the gateway license and change the ports to ethernet. Make sure the CX354A are set to ethernet If infiniband: You need to run a subnet manager before the link tuns up. For example there's opensm.exe in winof...