Thanks for replying, I not so sure that if my 6800xt is connected to this GPP Bridge, but the error is gone when I force the pcie runs at gen3 in bios. So there maybe some problem with pcie gen4.
Hi,
got a 7452QS with EPYCD8 and 6800xt, GPUZ shows that PCIE runs at Gen4,
but there comes a lot of PCIE error in windows event,
so question is if there is anyone use the 7452QS with PCIE Gen4 runs well without pcie error?
Thanks
Just a thought, maybe we could try to cross flash the bios of ROMED8 to EPYCD8, to see if it could boot, with the build-in Dr.Debug, maybe we could figure out how to get milan work on this board.
I have and 32c 57-04 qs, and the VID is 1.26v+ in 3.45G. When I manually set the voltage to 1.05v ,the cinebench r20 score is lower than 1.26v+, even lower than 3.0G.
Hi guys,
I recently purchase a 7452 QS 57-04 on EPYCD8, 8x16GB 2400.
And I found that some temperature in HWInfo64 was ridiculous high:
As you can see that "CPU Die (average)" was around 72°C and when I run the Prime95 torture test it'll quick raise up to 100°C (TjMax), but the CCD temp seems...
Or maybe we could extract the PSP fw from dell and then plant into our custom bios, but this base on the hypothesis that there is not any bios signed/verify procedure in EPYC boot
See through the article, I figure out that:
1. AMD has implement some mechanism that allow server vendor like DELL to install a public key into PSB (Platform Secure Boot), and then the system will only boot with the firmware signed with corresponding private key.
2. PSB (Platform Secure Boot) is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.