Hi,AFAIK it only supports Mikrotik's own discovery protocol
I just took some random SMF 1G transcievers and put one in my HP switch and the other in the CRS317, seems to link up perfect.
Mikrotik reports them as PeakOptical...
FYI: the switch doesn't recognice 10/1G dualmode transcievers (FTLX1471D3BCV-IT) when it tries to link 1G.
The dualmode transcievers didn't work no.Hi,
I'd like to connect my HP switch as well. To be clear you are saying that the FTLX1471D3BCV-IT doesn't work correct? What is the model number of the SMF 1G transceivers that work? What HP switch model do you have?
thanks,
Brendin
Yup, but that shouldn't matter too much.one on both ends right?
How loud are the fans when they kick in? Do they come on in normal use at normal (ie. not excessively hot) room temperatures?I have not tested it under full load yet. Below 40°C the switch is completely silent.
It has two 4-pin fans which starts at 2865 rpms. For some people it might be annoying, a specially when the switch is placed in non server rooms.Code:[admin@MikroTik] /system health> print temperature: 39C cpu-temperature: 38C psu1-state: ok psu2-state: ok fan1-speed: 0RPM fan2-speed: 0RPM
View attachment 6514
You could probably try to replace the fans with the silent equivalents or install another one on the heatsink at back to keep the temperature low.
The temperature tresholds could be a little higher. Need to check if the values can be adjusted.
My unit just arrived. Fired it up (fans have not spun up) before Rohit uses for the review.uh... can we get a STH review? With Xeon D and C3000 plz
Have you tested running iperf at the same time on 2 or more sets or isolated ports? Wondering how it does...I'm running SwOS on mine, but I ended up doing port isolation instead of VLANs as the performance went from 9,7 Gbps to 7,6 Gbps with VLANs enabled. :/
No performance hit with port isolation?I'm running SwOS on mine, but I ended up doing port isolation instead of VLANs as the performance went from 9,7 Gbps to 7,6 Gbps with VLANs enabled. :/
Not as far as I can see, though one of my hosts seems to have problems with it's NIC or cables as it only gets ~5.4 Gbps in iperf while the other does 9.3 Gbps.No performance hit with port isolation?