SuperMicro H11DSi-NT with AMD Epyc 7742 64 Core CPU

[Spartus]

Just any case some people don't know, for help with trying to get SSI-EEB motherboards into cases that don't accommodate all the holes. You can help support the board with these.

2.19US $ 20% OFF|50/100pcs/set Hc-5 Nylon Plastic Stick Fixed Clip On Pcb Spacer Standoff Locking Snap-in Fixed Clips Adhesive 3mm Hole Support - Screws - AliExpress

Smarter Shopping, Better Living! Aliexpress.com

www.aliexpress.com

11.43US $ 12% OFF|100pcs Rohs Nylon Plastic Electronic Spacer Reverse Pcb Circuit Board Support Pillar Flat-bottomed Aircraft Column Standoff - Screws - AliExpress

Smarter Shopping, Better Living! Aliexpress.com

www.aliexpress.com

2.3US $ 20% OFF|50pcs Hc-5/6/8/9/11/13 Nylon Plastic Stick On Pcb Spacer Standoff 3mm Hole Support Locking Snap-in Posts Fixed Clips Adhesive - Screws - AliExpress

Smarter Shopping, Better Living! Aliexpress.com

www.aliexpress.com

The hard part is getting the right height and diameter (god forbid you waste $2 buying extra )

 

[edge]

I dont think you should be ashamed, I had this exact problem. I had even masked unused risers with electrical tape as the case didnt have enough risers and 1/3rd of the board was without support. Turned out that the pins on the motherboard had gone through the electrical masks and it wasnt until i noticed some tiny holes in the masks that I figured it out.

I bought a tap and die set so I could add to a case if needed. I also always remove unused risers. I learned to do this by having your experience.