Hi,
So I'm trying to set up a new OmniOS 151036 VM on a new ESXi host.
I'm using vmxnet3 driver from solaris 10.3.10 iso right now, but was using open-vm-tools previously. Not seeing much difference between the two, I only switched to see what would happen since I'm seeing these slow incoming...
Hey,
so I just set up vmxnet3 drivers in OmniOS new install, 151028b on ESXi 6.7U1.
Went to test throughput to see what the difference between the E1000 and vmxnet3 drivers were like, so I fired up iperf3 on pfsense as a server, and sent the most basic test from the OmniOS VM as a client...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.