Okay, so there is a 2 pin that is labeled BMC Disable. Do I jump that one? That is the one directly under the 10Gbe mezz card. If that's the one then I don't understand the instructions in the README. It says jump it 2-3 then back to 1-2, how is this possible with only 2 pins.
I tried that but it just is a continuous beep. The system powers up but I can't see anything and the USB ports never become active.
Edit: A readme for the bios says to move JP26 to 2-3, recover the BIOS, then move the JP26 back to 1-2. Where the heck is JP26? Is it jumper 2 and jumper 6?
I was attempting to update to that BIOS version and the system locked up, I let it run for another 4 hours hoping it was a hiccup but it wasn't. Upon reboot, it just beeps over and over again, so she's dead. The server is now basically dead and I cannot reset the BIOS. I put AMIBOOT.ROM onto...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.