Ok thank you! But how can I do that? Is it a setting on the drive controller or somehow on the HDD itself? Because the drive is simply connected to the controller and not event mounted or does this even if its disconnected from the SAS and only powered.
Thanks!
Update (I'm not sure my last post is being showed because I edited it too much and is under approbation): After flashing the H310 to IT mode I could easily flash the new firmware.
The IR mode was not allowing direct passthrough. Didn't fix my clicking problem but eh
Hello,
I get the same error as sand_storm.
When I try to update my HUS724040ALS640 here is what I get:
root@schizo:~# sg_write_buffer -vv -m 5 --in=MPGNA3A0.bin /dev/sg3
open /dev/sg3 with flags=0x802
tried to read 8388608 bytes from MPGNA3A0.bin, got 1179648 bytes
will write 1179648 bytes...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.