I don't have too much in conf. I didn't run any dm commands, and I did "factory set-default" a couple of times now. Those commands results can be persistent somewhere (like the previous owner used them and now it "haunts" me :D ) ?
The switch' ports has these MACs before configuring the default VLAN: MACs and after they just get that address
Extra "info" i found is at the Boot Log "Unable to open /fast_iron/ka_link_reg.txt"
I already done it twice :D Maybe I should ask the seller what he means under the "Taken from a...
I removed the management port IP, saved it and reload (just in case)
Now the IPs:
switch: 192.168.2.2/24
pc nic1: 192.168.2.7/24
pc nic2: 10.1.150.2/16 gw 10.1.0.1
And the switch is only connected to that pc nothing else
Still not working but now I can't do too much with the other NIC which...
This could be the problem since the PCs that I used had 2 network adapters one connected to the switch the other one is to another network which is on different subnet (10.x.x.x) and had a default gateway (to the internet) and on the adapter which is connected to the switch I didn't configure...
Hi,
I have a ICX6610-48-HPOE and I'm stuck at the very first steps and I can't figure it out what (basic) mistake(s) I made.
I followed fohdeesha's guide to update the bootloader and the FW and factory reset (no problems here) but after the OS loads and I set up the basic network (disabling...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.