Search results

Hi guys, does anybody had pinout info for Tyan s7012 power connector, both 24-pin and 8-pin, I wondering if only 12V power supply is enough to power-up this board. The second question is about TEMP_SENSOR pin on Front_Panel connector, is anybody attached temperature sensor to it, if yes what...

just replace my cisco switch with another model, and Gig`s start to working, this not EEPROM issue, i think it negotiation capabilities problem, strange to see it in 2010, can anybody provide guidance in troubleshooting issue related to power drain, my mobo sometimes suddenly reloaded, i guess...

I observe strange issue, when I connect 2 ethernet ports on board I get 1Gbps link, I can use straight or crossover cable without any problem. But I am unable to get it working with any switch at 1Gbps, only one working setting is 100Mbps/Half-duplex hardcoded on switch port, as I understand I...

anybody trying update NICs eeprom, could you provide guidance, I download http://downloadmirror.intel.com/12344/eng/BootAgent.zip but cant understand how to use it

Guys can you share your jumper setting config which your motherboards have, is it possible to disable BMC|IPMI for clear NIC operation When I changed speed to 1000 in esxi VMWARE via VSphere, I lost my connection at all, i need to reinstall esxi, reseting via esxi management interface for...

hi, YES, I confirme that I have simular issue too, only static speed of 100 is working, if anybody knows solution please post here

Hi all, could somebody please post procedure for powering up TYAN S8208 motherboard outside the server case of DELLDCS6005, as I observe from the thread: pin 1-8 -- 12V pin 18 -- 5V pin 11-17,19 --GND is I need pin 20 to be used for any purposes or board start after power is connected? is pin...